| |
07-22-2006, 07:24 PM
| #1 |
| Junior Member Join Date: Oct 2001 Location: ky
Posts: 18
| Feed ramp question
I have a 45 that came with a bad slide , one side was milled so far off the rear slide serrations were almost gone at the top. It was priced accordingly and I mainly bought it for the rest of the pistol. My question is .... is there a differance between the 45 acp ramp in this frame and the one in a 10mm Delat Elite ? I think the 9 and 38 super are different than the 45 frame but didn`t know about the 10mm. This is a 80 series Colt and was wondering if it would be suitable for a 10mm build. |
 |
|
| Thread Tools | |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| polishing feed ramp | orel | Kahr Pistols | 20 | 09-02-2012 10:57 AM |
| PM9 - Bullet sticking on feed ramp | Tito | Kahr Pistols | 13 | 04-20-2004 06:16 PM |
| Feed ramp dings | likestoshoot | Kimber Pistols | 5 | 01-09-2004 10:00 PM |
| Feed Ramp polishing | John P | Workshop | 6 | 03-22-2003 01:03 PM |
| Sig P220 Feed Ramp | dasroofr | SIG Pistols | 2 | 03-04-2003 03:53 PM |
Linear Mode
