pt945 not feeding reloads

roland · 10-02-2001, 09:22 PM

Any thoughts or comments on the pt 945? I'm thinking of getting one. Any advice welcome.

Ned Christiansen · 10-03-2001, 07:59 AM

The one that I have had in the shop was not good, and I generally think Taurus auto are OK, so it's not that I'm predisposed to not like them. I believe there was actually a cut missing in the feedramp area, and it would not feed hardball, not one. Rounds would go forward and actually get hooked and deforemed on two protrusions. I'm sure they can't all be like this, but Taurus was not very forthcoming about it-- which I think was a fluke. Aren't they usually great on warranty stuff? The gun looks kinda cool, but the sight plane/bore axis are very high. That's about all I know....

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Taurus 24/7 .45 cal.	45 Hal	Pictures	4	10-08-2005 08:57 AM
Taurus M66	EddieGunnZ	Revolvers	4	05-29-2005 01:42 PM
taurus 41 mag.	handyman4x4	Revolvers	0	09-10-2004 04:07 PM
Taurus 605 or Old S&W 66-1?	Ronin21	Revolvers	6	03-28-2004 01:25 PM
Taurus 218 BEE	norm rock	Revolvers	0	01-11-2004 04:29 PM

10-02-2001, 09:22 PM	#1
roland Junior Member Join Date: Oct 2001 Posts: 10	Any thoughts or comments on the pt 945? I'm thinking of getting one. Any advice welcome.

10-03-2001, 07:59 AM	#2
Ned Christiansen Senior Member Join Date: Jun 2001 Posts: 687	The one that I have had in the shop was not good, and I generally think Taurus auto are OK, so it's not that I'm predisposed to not like them. I believe there was actually a cut missing in the feedramp area, and it would not feed hardball, not one. Rounds would go forward and actually get hooked and deforemed on two protrusions. I'm sure they can't all be like this, but Taurus was not very forthcoming about it-- which I think was a fluke. Aren't they usually great on warranty stuff? The gun looks kinda cool, but the sight plane/bore axis are very high. That's about all I know....