G'Smith for custom work on a 12.45 LDA?

BIG SAM · 11-05-2006, 12:42 PM

I have recently purchased a used 12.45 LDA and it has been shot a good bit.

Does anyone have recommendations for a 'smith' who works on these models?

Night sights (not a dove tail front)
Accuracy barrel work.
General tune-up, etc.

Thank you for your reply.

Cheers,

Sam

6285108 · 11-05-2006, 03:35 PM

www.novaksights.com will do a fine job on it and yes they do more than just sights

buddy_fuentes · 11-06-2006, 12:17 PM

Either cylinder and Slide Shop or Evolution Gun Works does nice work on the LDA's. I have seen one that was worked over and it was really nice. Accuracy and trigger were top shelf.

One of mine has a 4# trigger and everyone that feels it thinks it is two to two and a half pounds. It just feels that good and it is stock. Think about what a good gunsmith could do.

May be worth inquiring if you are looking to have that special gun.

Good luck

11-05-2006, 12:42 PM	#1
BIG SAM Junior Member Join Date: Nov 2006 Posts: 1	G'Smith for custom work on a 12.45 LDA? I have recently purchased a used 12.45 LDA and it has been shot a good bit. Does anyone have recommendations for a 'smith' who works on these models? Night sights (not a dove tail front) Accuracy barrel work. General tune-up, etc. Thank you for your reply. Cheers, Sam

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need smith to work on a police positive	mollydodger	Gunsmith Locations	2	04-30-2005 01:40 PM
'smith for bobbed hammer/trigger work	chrisr	SIG Pistols	2	03-24-2005 12:49 PM
One gun, no mods, no smith work - what would it be?	Spackler4013	Gun Talk	106	08-26-2002 01:31 AM
How Many Pistols does a Custom smith Make/Work on in a Year	Westicle	Pistolsmiths	27	05-09-2002 09:38 PM
beater guns to purchase for smith work	legalhack	Pistolsmiths	9	05-03-2001 09:44 PM

11-05-2006, 03:35 PM	#2
6285108 Member Join Date: Mar 2004 Location: Cleveland, Oh Posts: 58	www.novaksights.com will do a fine job on it and yes they do more than just sights

11-06-2006, 12:17 PM	#3
buddy_fuentes Senior Member Join Date: Nov 2003 Location: Maurepas, LA Posts: 571	Either cylinder and Slide Shop or Evolution Gun Works does nice work on the LDA's. I have seen one that was worked over and it was really nice. Accuracy and trigger were top shelf. One of mine has a 4# trigger and everyone that feels it thinks it is two to two and a half pounds. It just feels that good and it is stock. Think about what a good gunsmith could do. May be worth inquiring if you are looking to have that special gun. Good luck