pistol with 4 holes

jrothWA · 01-15-2010, 09:39 PM

Hello,

Local shop has a BHP (Mark III) that was drilled and tapped for possible rail attachment for light/laser, on the forward frame.

It's the cast frame, would Browning/FN or someone else, be able to weld up??

It's nickled/chrome, too boot!

(darn idiots, that buy their way to shooting abilities, to avoid PRACTISE!!) :evil:

Stephen A. Camp · 01-25-2010, 05:18 PM

Hello. I flat don't know the answer to your question. I'd check with Novaks, Ted Yost or other well-known 'smiths.

Best and good luck.

Larry Pomykalski · 02-21-2010, 07:22 AM

George at EGW is pretty well known for his welding abilities. But with the expense of welding and dressing the fill, combined with refinishing, I think it's going to be a pretty stiff bill. Might want to find another gun to lust after....

Larry

01-15-2010, 09:39 PM	#1
jrothWA Join Date: Jan 2007 Posts: 3	4 extra holes Hello, Local shop has a BHP (Mark III) that was drilled and tapped for possible rail attachment for light/laser, on the forward frame. It's the cast frame, would Browning/FN or someone else, be able to weld up?? It's nickled/chrome, too boot! (darn idiots, that buy their way to shooting abilities, to avoid PRACTISE!!) :evil:

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Extra power springs for PM9	bigboyhf	Kahr Pistols	1	07-16-2008 03:51 PM
opinion: Should I get rid of Extra 228?	iluvcrap2000	SIG Pistols	2	01-03-2006 07:22 AM
Extra Mag w/ PM9	darthskeeter	Kahr Pistols	3	03-12-2004 01:53 PM
Anybody got an extra EAA Witness top end in 10mm and want 45	recondoc	10mm	0	10-17-2003 01:38 PM
Is the new 70 series colt worth the extra $$$	Jo Mama	Colt Pistols	6	12-11-2002 10:36 AM

01-25-2010, 05:18 PM	#2
Stephen A. Camp Senior Member Join Date: Mar 2001 Location: Southwest Posts: 2,371	Hello. I flat don't know the answer to your question. I'd check with Novaks, Ted Yost or other well-known 'smiths. Best and good luck.

02-21-2010, 07:22 AM	#3
Larry Pomykalski Senior Member Join Date: Mar 2001 Location: Illinois Posts: 148	George at EGW is pretty well known for his welding abilities. But with the expense of welding and dressing the fill, combined with refinishing, I think it's going to be a pretty stiff bill. Might want to find another gun to lust after.... Larry