A not so slippery slide - Pistolsmith
Pistolsmith

Go Back   Pistolsmith > Pistol Forum > Browning Pistols

Reply
 
LinkBack Thread Tools Display Modes
Old 09-17-2017, 11:56 PM   #1
Junior Member
 
Join Date: Sep 2017
Location: Hampton,VA
Posts: 3
I have an I have a Belgian made FN Browning hi-power that I reblued. I just put everything back in place and as I go to connect a slide to the frame it hangs up 6.6 mm from battery. I have checked the recoil spring, the sear, the ejector, the hand for the trigger as well as the trigger positioning itself. It is Well oiled but not over greased and I cannot see any obvious spots Where Metal is rubbing Am I missing something? Because I cannot see anything that is holding it up from returning to where it's supposed to be so I can put the slide lock/disassembly lever back in place. Any and all help is appreciated. Thank you.

the flash distorts the blueing color fyi
Attached Images
File Type: jpg 0918170237-1_1505721274739.jpg (723.2 KB, 5 views)
File Type: jpg 0918170435-1_1505723908154.jpg (770.9 KB, 5 views)
File Type: jpg 0918170434_1505723919541.jpg (331.0 KB, 6 views)
File Type: jpg 0918170437-1_1505723958656.jpg (912.2 KB, 5 views)

Last edited by Jackfrawst; 09-18-2017 at 12:40 AM.
 
Remove Ads
Old 09-18-2017, 04:37 PM   #2
Senior Member
 
Join Date: Jun 2001
Posts: 1,800
Go with the trouble shooting method.......

Install JUST the slide on the frame and check for free and full travel.
Then install just the barrel in the slide and test again, then the recoil spring and guide.

This should point out which part is causing the problem.
If you can't get the bare slide on, start looking for things in the slide and frame for interference.
 
Old 09-20-2017, 02:25 AM   #3
Junior Member
 
Join Date: Sep 2017
Location: Hampton,VA
Posts: 3
After going through everything twice it dawned on me that the extractor that I was given when I bought the gun was slightly different than the extractor that I took out and replaced so I went and switched it back and it works perfect now. Thank you for your response
Attached Images
File Type: jpg 0919170705_1505903177977.jpg (697.7 KB, 4 views)
 
Reply

  Pistolsmith > Pistol Forum > Browning Pistols

Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
slide jamming on norinco 1911 9mm cal.al M1911 Pistols 4 07-01-2018 06:59 PM
New Glock 17-L Long Slide billt Glock Pistols 1 09-25-2017 11:12 AM
EAA Witness 9mm jamming problem Reno CZ Pistols 3 09-18-2017 04:43 PM

Top Gun Sites Top Sites List


Powered by vBulletin 3.8.8
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.1
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright © 1999-2012 Pistolsmith. All rights reserved.