Browning HI Power trigger reset - Page 2 - Pistolsmith
Pistolsmith

Go Back   Pistolsmith > Pistolsmith Forum > Pistolsmiths > Gunsmith Guides

Like Tree1Likes
Reply
 
LinkBack Thread Tools Display Modes
Old 12-18-2014, 10:28 PM   #11
Senior Member
 
Join Date: May 2006
Location: near Huntsville, Ala.
Posts: 707
Welcome to Pistolsmith. Good first post.
 
Remove Ads
Old 12-22-2014, 11:19 AM   #12
Junior Member
 
Join Date: Dec 2014
Location: michigan
Posts: 2
bhp trigger reset experiment follow up

follow up from my previous post:

1. The sear lever has three functions: a) push on the sear when pushed on by trigger lever, b) allow the trigger to disconnect/reset after firing cycling sequence is complete, and c) (for MKIII pistols) to unblock the firing pin when pused on by the trigger lever, or block the firing pin when pushed on by the sear lever spring. I had forgotten to test function c) after the sear lever modification...and discovered that the added weld was enough to move the sear lever and disengage the firing pin block. potential fix would be to add material in the area of the firing pin block, or to ad the adjustment setscrew where it engages the firing pin as well as the pocket in the slide.

2. I re-installed the magazine disconnect. Noticed some grittiness during the initial takeup. Polished the magazine disconnect contact surface, and the corresponding surface on the magazine. This helped the grittiness significantly, but there is some uneven pressure. I suspect it is from the magazine disconnect plunger spring rubbing against the inner diameter edge of the disconnect plunger. Not sure what can be done about this... any thoughts?
 
Reply

  Pistolsmith > Pistolsmith Forum > Pistolsmiths > Gunsmith Guides


Search tags for this page
browning hi power short reset trigger
,
browning hi power trigger lever
,

browning hi power trigger reset

,
browning hi-power trigger does not reset
,
hi power sear lever
,

hi power trigger reset

,
hi power trrigger reset spring
,
install cylinder & slide browning high power sear lever install
,
smoother trigger with a faster reset for the browning hi power
Click on a term to search for related topics.

Thread Tools
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
Removing The FN-Browning High Power Trigger Pin. Bob Reed Browning Pistols 0 04-16-2009 05:22 PM
trigger reset recoil33 Colt Pistols 2 02-21-2006 08:34 AM
Browning Hi-Power Trigger Pull? Sgt. Mike Browning Pistols 2 11-03-2003 08:31 PM
Trigger reset TRIP M1911 Pistols 1 12-29-2002 08:18 PM
Trigger reset guipago SIG Pistols 4 07-03-2002 01:03 PM

Top Gun Sites Top Sites List


Powered by vBulletin 3.8.8
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.1
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright © 1999-2012 Pistolsmith. All rights reserved.