How to strip the frame on a Kahr polymer pistol? - Pistolsmith

Go Back   Pistolsmith > Pistol Forum > Kahr Pistols

LinkBack Thread Tools Display Modes
Old 02-27-2002, 11:41 PM   #1
Join Date: Feb 2002
Posts: 2
Hello, new poster here. Great forum, learned a lot by "lurking" for months!

I would like to thoroughly clean and get some Tetra grease on the fire control parts of my P9 (cocking cam, trigger bar where it contacts cam, etc.). Has anyone ever stripped the frame on any of the Kahr polymer pistols? Do you just use a punch to push out the pin that holds the side panel on? Any pitfalls to be aware of? Thanks in advance for any replies!
Remove Ads
Old 03-02-2002, 07:18 PM   #2
Join Date: Dec 2001
Posts: 20
The P40 I had would start to take the pins out on it's own after about twenty rounds, then I would tap them back in. I didn't keep it long enough to have to find out how to do it on purpose.

<font size=-1>[ This Message was edited by: IRock on 2002-03-02 19:19 ]</font>

  Pistolsmith > Pistol Forum > Kahr Pistols

Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
advice on new polymer kahr LASTCALL Kahr Pistols 1 02-05-2005 05:17 PM
Durability of Kahr polymer frames? steven matthews Kahr Pistols 9 11-11-2004 07:28 PM
How Do You Clean Your Polymer Kahr? tarpon6 Kahr Pistols 1 01-11-2004 06:15 PM
kahr polymer p9 bigray Kahr Pistols 2 12-10-2002 02:32 PM
Kahr polymer frame MP9 Tito Glock Pistols 2 03-21-2002 03:35 PM

Top Gun Sites Top Sites List

Powered by vBulletin 3.8.8
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.1
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright © 1999-2012 Pistolsmith. All rights reserved.