H&r 649 - Pistolsmith
Pistolsmith

Go Back   Pistolsmith > Revolver Forum > Revolvers

Reply
 
LinkBack Thread Tools Display Modes
Old 03-02-2015, 05:54 AM   #1
Member
 
Louisiana Gunny's Avatar
 
Join Date: Jul 2013
Location: Louisiana
Posts: 36
H&r 649

I was brought a 649 in pieces. The original gunsmith had an aneurism and is no longer able to work on guns. When I put it back together, the first time I cock the hammer, the cylinder rotates. After that initial time, everything moves except the cylinder. When I took it back apart, it seemed to me that the other smith may have trimmed the lever spring too much. I put a new one from Numerichs in and am slowly trimming it. However, before I cut it too short, I wanted to pimp you for advice. The lever spring and lever easily fall back and out of the hole when I put my thumb over it while the cylinder is out of the pistol during cocking. The schematic is quite busy, but I don't think anything is missing. Any thoughts?
 
Remove Ads
Old 08-19-2015, 11:49 AM   #2
Junior Member
 
Join Date: Jan 2006
Location: Upper Sandusky OH
Posts: 4
I would like some information on fitting the lever as well. I am having the same problem with a H&R 900 .22 revolver as well.
 
Reply

  Pistolsmith > Revolver Forum > Revolvers


Search tags for this page

h & r 649 revolver

,

h&r 649 cylinder

,

how to time a h&r 649 revolver

Click on a term to search for related topics.

Thread Tools
Display Modes


Top Gun Sites Top Sites List


Powered by vBulletin 3.8.8
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.1
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright © 1999-2012 Pistolsmith. All rights reserved.